It is used to protect the horizontal joints between sheets of siding from water infiltration.
Z bar flashing installation.
The large leg of the metal goes against the wall leaving the seat and face covering the top edge of the siding.
Thd sku 686080.
The seat dimension 3 8 in corresponds to the siding thickness.
Z bar design easily accommodates rigid insulation.
Check out our recommended tools right here.
If only the surface is damaged.
Backleg made of 28 gauge galvanized steel.
Galvanized steel z flashing is made from 28 gauge galvanized steel.
How to install z flashing on rotted t1 11 siding 1.
Galvanized steel unless specified.
Test the rotted area of the t1 11 siding by poking it with a nail or a screwdriver.
Begin at either end of the wall and set the level middle section of the z flashing onto the top edge of the siding panel with the wider flange upward and against the wall framing.
Scrape loose paint off the rotted area with a putty knife and use 80 grit sandpaper to smooth the rough surface if.
Steel z bar flashing with 2 in.
Window and door cap 1 25 in x 120 in x 1 56 in aluminum z flashing.
Item 3807 model 5504900120.
Suitable for residential or commercial use.
Subject to inquiry for availability.
Bailey s z bars are ideal for many construction applications such as continuous framing insulation reinforcement slides track and roofing.
Flush the end of the flashing length with the wall corner and secure the flashing to the framing with an 8d nail at each wall stud.
Z bar flashing provides an inexpensive and easy to install method of stopping water penetration behind siding.
Flanges are available in lengths of 1 1 1 1.
Designed for roofing applications.
Place the z flashing into position on top of the casing.
