The door lock switches use a supplied ground to send a signal to the bcm.
09 535i rear door lock inop.
In order to remove the door panel.
I could be walking away and it locks.
Remember it wasn t that long ago that we were stuck manually rolling up windows turning a key to start the car and scanning the radio hoping to find a tolerable song to listen to on the radio while we were stuck in rush hour traffic.
The first time i noticed it was when i needed to get in that door.
The driver s side door lock switch does not work lock or unlock.
Unbolt the door lock assembly from the door and then pull the assembly out.
The vehicle will lock itself randomly regardless if the keyfob is in the vehicle or not or even near it.
Why door lock failure occurs in a bmw 26 mar 18.
It was stuck in the locked position.
The door lock fuse is at the top.
11 ltz rjt v6 a6 in flood at 44k miles.
Reverse the process when you install the new door lock assembly.
If you have a single door which doesn t lock unlock you most likely have a problem with the actuator motor.
To lock the doors the bcm gets a true ground.
When this is the problem you will need to remove the door panel and have a look.
The modern conveniences of vehicles are often lost upon drivers today.
The engine is always off.
Push down the plastic clip on the door handle rod.
My 2014 double cab rear passenger door started doing this a couple weeks ago.
There is a plastic clip attached to this rod.
To unlock them it gets a signal through a resistor going to ground.
I can opening or closing the rear door and it locks.
Push down the clip to loosen the rod then pull the rod up and out of the door.
First unhook the negative battery power.
Single door fails to lock unlock.